Procedural Steps: - TM-5-3835-222-BD0115

TM 5-3835-222-BD

j. Carefully slide piston-rod end assembly back into cylinder body.

k. Replace bolts holding rod end of cylinder to cylinder body and tighten.

i. Install repaired cylinder.

m. Check that the hydraulic reservoir level is at least at the minimum operating level. If this level

is low, refer to para 8-13 and fill the reservoir as needed.

n. Operate all hydraulic subsystems (except those that may still be damaged) to remove air from

the system. Check carefully for fluid leaks. Tighten leaking fittings.

o. Check the hydraulic reservoir again to ensure a sufficient hydraulic fluid level. If this level is

low, refer to para 8-13 and fill the reservoir as needed.

p. Record the BDAR action taken. When the mission is completed as soon as practicable,

repair using standard maintenance procedures.

8-33