Low Pressure Isolation - Using Tubes and Clamps.

TM 5-3835-222-BD

h. Check the hydraulic reservoir again to ensure a sufficient hydraulic fluid `level. If this level

is low, refer to para 8-13 and fill the reservoir as needed.

i. Record the BDAR action taken. When the mission is completed, as soon as practicable,

repair using standard maintenance procedures.

8-6.3. Low Pressure Isolation - Using Tubes and Clamps.

Limitations:

Isolation recommended for low-pressure hose repairs only.

Personnel/Time Required:

1 soldier - 50 minutes

MateriaIs/Tools:

Tape

Saw

Hose Clamp(s)

Tool Kit

Tubing (appendix C, section II, item 45)

Procedural Steps:

a. Squarely cut the end of the damaged hose (see para 8-15).

b. Cut the ends of the tubing squarely (see para 8-17).

c. Flatten one end of the tubing six inches.

d. Crimp the tube using the four steps as shown below.

8-10