 |
|||
|
|
|||
|
Page Title:
Section V. INTERMEDIATE SUPPORT TEST PROCEDURES |
|
||
| ||||||||||
|
|
 TM 32-5811-024-14&P
(d) Remove four power supply module mounting screws and lift from unit.
b. Assembly. Digital processor test set assembly consists of installing the blower and power supply module.
(1) Blower installation.
(a) Position blower (from top of unit) onto heat sink and reconnect tagged blower wires as indicated.
(b) Secure blower to heat sink by tightening four mounting screws from bottom of unit.
(c) Position safety cover on bottom of heat sink and secure with 14 mounting screws.
(d) Position power supply top cover on heat sink (top side) and secure with 12 mounting screws.
(e) Reinstall top and bottom covers.
(2) Power supply module installation.
NOTE
Place a thin layer of silicone heat sink grease between the power supply module and heat sink
before installing the module.
(a) Position power supply module to mounting surface and secure with four screws.
(b) Connect tagged power supply module wires to terminals as indicated.
(c) Position power supply cover and secure with 12 mounting screws.
(d) Reinstall top cover.
Section V. INTERMEDIATE SUPPORT TEST PROCEDURES
6-9. General.
This section provides intermediate support testing procedures for the digital processor test set. The test procedures
indicate whether a new or repaired unit is capable of performing its assigned mission.
6-7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals