|
|
TM
3-1040-279-12&P
9. Rotate spacers (13) to center equipment container in frame assembly and provide the smallest
possible gap. Both spacers on any one side of the frame assembly must be positioned the same.
Install but don not tighten eight screws (19), lock washers (11), washers (12), and four spacers
(13).
10. Tighten screws (10) on one side of frame assembly. Insert shims (14) between frame and spacers
on other side of frame assembly as required for a snug fit. An equal number of shims should be
used for each spacer on each side of generator.
11. Torque screws (10) to 12 lb-ft.
12. Tighten eight screws (4) securing angle brackets (6) to equipment container (8) and frame
assembly (9).
13. Install equipment container side panels (3) using eight screws (1) and washers (2).
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |