SECTION I. INTRODUCTION - TM-11-6625-3030-24P0003

TM 11-6625-3030-24P

SECTION I.

INTRODUCTION

Code

Definition

1. Scope

PA-Item procured and stocked for anticipated or known

usage.

This manual lists spares and repair parts; special tools;

PB-Item procured and stocked for insurance purpose

special test, measurement, and diagnostic equipment

because essentially dictates that a minimum

(TMDE), and other special support equipment required

quantity be available in the supply system.

for performance of organizational, direct support, and

PD-Support item, excluding support equipment, procured

general support maintenance of the PL-1306/U. It

for initial issue or outfitting and stocked only for

authorizes the requisitioning and issue of spares and

subsequent or additional initial issues or outfittings.

repair parts as indicated by the source and maintenance

Not subject to automatic replenishment.

codes.

XA-Item is not procured or stocked because the

requirements for the item will result in the

2. General

replacement of the next higher assembly.

XB-Item is not procured or stocked. If not available

This Repair Parts and Special Tools List is divided into

through salvage, requisition.

the following sections:

XD-A support item that is not stocked. When required,

a. Section II. Repair Parts List. A list of spares and

item will be procured through normal supply

repair parts authorized for use in the performance of

channels.

maintenance. The list also includes parts which must be

removed for replacement of the authorized parts. Parts

NOTE

lists are composed of functional groups in numeric

sequence, with the parts in each group listed in figure

Cannibalization or salvage may be used

and item number sequence.

as a source of supply for any items

b. Section IlI Special Tools List. Not applicable.

source coded above except those coded

c. Section IV National Stock Number and Part

XA and aircraft support items as

Number Index. A list, in National item identification

restricted by AR 700-42.

number (NIIN) sequence, of all National stock numbers

(NSN) appearing in the listings, followed by a list, in

(2) Maintenance code. Maintenance codes are assigned

alphanumeric sequence, of all part numbers appearing in

to indicate the levels of maintenance authorized to USE

the listings. National stock numbers and part numbers

and REPAIR support items. The maintenance codes are

are cross-referenced to each illustration figure and item

entered in the third and fourth positions of the Uniform

number appearance.

SMR Code format as follows:

(a) The maintenance code entered in the third position

3. Explanation of Columns

will indicate the lowest maintenance level authorized to

remove, replace, and use the support item.

The

a. Illustration This column is divided as follows:

maintenance code entered in the third position will

(1) Figure number. Indicates the figure number of

indicate one of the following levels of maintenance:

the illustration on which the item is shown.

(2) Item number. The number used to identify item

Code

Application/Explanation

called out in the illustration.

H-Support item is removed, replaced, used at the general

b. Source, Maintenance, and Recoverability (SMR)

support level.

Codes.

(b) The maintenance code entered in the fourth

(1) Source code. Source codes indicate the

position indicates whether the item is to be repaired and

manner of acquiring support items for maintenance,

identifies the lowest maintenance level with the capability

repair, or overhaul of end items. Source codes are

perform

complete

repair

(i.e.,

entered in the first and second positions of the Uniform

SMR Code format as follows: