CONNECTOR UG-1870A/U REPLACEMENT (CONT) - TM-11-5995-208-24-P-10039

TM 11-5995-208-24&P-1

CONNECTOR UG-1870A/U REPLACEMENT (CONT)

NOTE

Be sure braid clamp (6) is still fully under outer copperweld braid before crimping the

crimp sleeve (5).

30. Position large crimp sleeve (5) flush against braid clamp (6).

31. Using hex crimping tool (item 13, section 3, appendix B), crimp the crimp sleeve (5).

32. lnstall small O-ring (7) on each center contact against center contact flange (8).

NOTE

Be sure large counterbores of rear insert (9) are facing away from hexagonal clamp nut

(10) of coaxial braid clamp assembly when installed.

33. Install rear insert (9) over both coaxial cables.

3-13