SECTION I INTRODUCTION - TM-11-5935-212-13P0005

TM 11-5935-212-13P

SECTION I

INTRODUCTION

Scope

Code

Definition

T h i s manual lists spares and repair parts; special

PA--

I t e m procured and stocked for anticipated

tools; special test, measurement, and diagnostic

o r known usage.

equipment (TMDE), and other special support

XD--

A support item that is not stocked. When

e q u i p m e n t required for performance of organiza-

r e q u i r e d , item will be procured through

tional and direct support maintenance of the

normal supply channels.

U-185A/G and U-185B/G. It authorizes the requisi-

NOTE

tioning and issue of spares and repair parts as

Cannibalization or salvage may be used

i n d i c a t e d by the source and maintenance codes.

as a source of supply for any items source

2. General

coded above except those coded XA and

aircraft support items as restricted by AR

This repair Parts and Special Tools List is divided

700-42.

i n t o the following sections:

(2) M a i n t e n a n c e c o d e . M a i n t e n a n c e c o d e s a r e

a. Section II. Repair Parts List. A list of spares

a s s i g n e d to indicate the levels of maintenance au-

a n d repair parts authorized for use in the perfor-

t h o r i z e d to USE and REPAIR support items. The

mance of maintenance. The list also includes parts

maintenance codes are entered in the third and

which must be removed for replacement of the

f o u r t h positions of the Uniform SMR Code format

authorized parts. Parts lists are composed of func-

as follows:

t i o n a l groups in numeric sequence, with the parts

(a) T h e m a i n t e n a n c e c o d e e n t e r e d i n t h e

in each group listed in figure and item number

t h i r d position will indicate the lowest maintenance

sequence.

l e v e l authorized to remove, replace, and use the

b. Section III. Special Tools List. Not applicable.

support item. The maintenance code entered in the

c. Section IV. National Stock Number and Part

third position will indicate one of the following

N u m b e r I n d e x . A list, in National item identifica-

l e v e l s of maintenance:

tion number (NIIN) sequence, of all National stock

Application/Explanation

Code

n u m b e r s (NSN) appearing in the listings, followed

F--

S u p p o r t item is removed, replaced, used at

by a list, in alphameric sequence, of all part num-

t h e direct support level.

bers appearing in the listings. National stock

(b) T h e m a i n t e n a n c e c o d e e n t e r e d i n t h e

n u m b e r s and part numbers are cross-referenced to

fourth position indicates whether the item is to be

e a c h illustration figure and item number appear-

repaired and identifies the lowest maintenance

ance.

l e v e l with the capability to perform complete re-

pair (i.e., all authorized maintenance functions).

3. Explanation of Columns

This position will contain one of the following

a. Illustration. This column is divided as follows:

maintenance codes:

(1) F i g u r e n u m b e r . Indicates the figure

Application/Explanation

Code

n u m b e r of the illustration on which the item is

Z--

N o n r e p a r a b l e . No repair is authorized.

shown.

(3) R e c o v e r a b i l i t y c o d e . R e c o v e r a b i l i t y

codes

(2) Item number. The number used to identify

are assigned to support items to indicate the

dispo-

item called out in the illustration.

sition action on unserviceable items. The

recov-

b. Source, Maintenance, and Recoverability

erability code is entered in the fifth position

of the

(SMR) Codes.

U n i f o r m SMR Code format as follows:

(1) S o u r c e c o d e . S o u r c e c o d e s i n d i c a t e t h e

Recoverability

manner of acquiring support items for mainte-

Definition

codes

nance, repair, or overhaul of end items. Source

Z--

Nonreparable item. When unserviceable,

codes are entered in the first and second positions

condemn and dispose at the level indi-

of the Uniform SMR Code format as follows:

cated in position 3.