Row 1 Equipment Bays - TM-11-5895-932-14-P0010

TM11-5895-932-14&P

1.4, and 1.5, black IDF bay 1.6, black patch bay

Cable ducts for carrying signal and power cables

1.7, test equipment bay 1.8, VF frame and patch

between the cabinets are installed under the floor.

Conduits from the cable ducts bring the cables and

bay 1.9, and miscellaneous bay 1.10. The Western

power under the center of the cabinets. In addition, a

Union and Timplex modems are furnished and

large conduit is connected between the signal line

maintained by contractors. A configuration of

filter panel (located in the ceiling) into the cable duct

equipment bays is shown in figure 1.3.

to carry the entrance signal cable in the PTF. Power

a. Western Union Bay 1.1. Western Union

for operating the cabinet components is taken from

(WU) modems are installed in bay 1.1. The cabinet

outlets installed in the rear of cabinets or are wired

is connected to the underground cable ducts with

directly. The COMSEC equipment bays (3.1 through

conduits that carry signal cables and black power.

3.4) in the cryptovault are part of special circuits not

The signal cable terminates on the VR entrance

covered in this manual.

frame (channels 47 and 48).

b. Modem Bays 1.3, 1.4, and 1.5 (fig.

1-9. Row 1 Equipment Bays

1-4). Modem bay 1.3 contains a WU Codex 9600

The Row 1 equipment bays are located in the left

Data Modem, an associated patch panel, and eight

side of the comcenter. Row 1 equipments (fig. 1-2)

additional WU 2200/24

include Western Union bay 1.1, modem bays 1.3,

1-4