SECTION I INTRODUCTION - TM-11-5895-365-24P0005

SECTION I

INTRODUCTION

Definition

1. Scope

Code

stocked only for subsequent or additional ini-

This manual lists repair parts and special tools re-

tial issues or outfittings. Not subject to auto-

quired for performance of organizational, direct sup-

matic replenishment.

port, and general support maintenance of the AN/

XD--A support item that is not stocked. When re-

GSQ-80, AN/GSQ-80A, and AN/GSQ-80B.

quired, item will be procured through normal

supply channels.

2. General

This Repair Parts and Special Tools List is divided

NOTE

into the following sections:

Cannibalization or salvage maybe used as a

a. Section II. Repair Parts List. A list of repair

source of supply for any items source coded

parts authorized for use in the performance of mainte-

above except those coded XA, XD, and air-

nance. The list also includes parts which must be re-

craft support items as restricted by AR

moved for replacement of the authorized parts. Parts

700-42.

lists are composed of functional groups in ascending

numerical sequence, with the parts in each group

(2) Maintenance code. Maintenance codes are as-

listed in figure and item number sequence.

signed to indicate the levels of maintenance authorized

b. Section III. Special Tools List. Not applicable.

to USE and REPAIR support items. The maintenance

c. Section IV. National Stock Number and Part

codes are entered in the third and fourth positions of

Number Index. A list, in ascending National item

the Uniform SMR Code format as follows:

identification number (NIIN, last 9 digits) sequence,

(a) The maintenance code entered in the third

of all National stock numbers appearing in the listings,

position will indicate the lowest maintenance level au-

followed by a list, in alphameric sequence, of all part

thorized to remove, replace, and use the support item.

numbers appearing in the listings. National stock

The maintenance code entered in the third position

number and part numbers are cross-referenced to

will indicate one of the following levels of maintenance:

each illustration figure and item number appearance.

Application/Explanation

Code

3. Explanation of Columns

O--Support item is removed, replaced, used at the

organizational level.

The following provides an explanation of columns

F--Support item is removed, replaced, used at the

found in the tabular listings:

direct support level.

a. Illustration. This column is divided as follows:

H--Support item is removed, replaced, used at the

(1) Figure number. Indicates the figure number

general support level.

of the illustration in which the item is shown.

(b) The maintenance code entered in the fourth

(2) Item number. The number used to identify

position indicates whether the item is to be repaired

each item called out in the illustration.

and identifies the lowest maintenance level with the

b. Source, Maintenance, and Recoverability Codes

capability to perform complete repair (i. e., all au-

(SMR).

thorized maintenance functions). This position will

(1) Source code. Source codes are assigned to

contain one of the following maintenance codes:

support items to indicate the manner of acquiring sup-

port items for maintenance, repair, or overhaul of end

Application/Explanation

Code

items. Source codes are entered in the first and second

O--The lowest maintenance level capable of complete

positions of the Uniform SMR Code format as follows:

repair of the support item is the organizational

level.

Definition

Code

F--The lowest maintenance level capable of complete

PA--Item procured and stocked for anticipated or

repair of the support item is the direct support

known usage.

level.

PD--Support item, excluding support equipment,

H--The lowest maintenance level capable of complete

procured for initial issue or outfitting and