SECTION IV PREPARATION FOR RESHIPMENT - TM-11-5805-688-14-10096

T.O. 31W2-2GSC24-2

TM 11-5805-688-14-1

NAVELEX 0967-LP-545-3011

SECTION IV

PREPARATION FOR RESHIPMENT

3-99.

GENERAL.

3-100. This section contains instructions for preparing

2. Remove and retain 12 screws and washers

the multiplexer set for shipment. The original shipping

securing two rack-mounting flanges to electronic

container, padding, and filler should be used for packing

equipment rack.

the multiplexer set for shipment.

3. Carefully extend multiplexer set upon its

3-101.

PACKING PROCEDURES,

mounting slides until slides lock in extended position.

4. Disconnect power cable from primary power

source and from multiplexer set.

5. Disconnect

remote

alarms

cable

from

multiplexer set, and disconnect all input/output data and

The

multiplexer

set

timing signal cables.

weighs 140 pounds. Use a

6. Release the extender slide locks and carefully

mechanical lifting device

remove multiplexer set from rack. Place multiplexer set

whenever possible.

on a suitable work bench or surface.

prevent

injury

personnel,

7. Remove two outer extender slide sections

recommended

that

secured to electronic equipment rack.

Retain all

minimum of four men be

mounting hardware.

used when a multiplexer

set is to be lifted

8. Install two outer extender slide sections removed

manually.

in step 7 on two inner slide sections mounted on multi-

plexer set.

1. Set POWER CONTROL switch to OFF.

9. Verify that all captive screws on front panel and

NOTE

top panel of multiplexer set are securely fastened.

Perform the procedures in

NOTE

steps 2 through 10 when the

multiplexer set is rack

When

original

shipping

mounted and uses the

container is not available, pre-

extendable

slides

for

pare multiplexer set for shipment

support. Proceed to step 11

in accordance with currently

when the multiplexer set is

applicable

packaging

secured to a rack only by its

instructions

for

electronic

two rack-mounting flanges.

equipment.

When the multiplexer set is

installed on a flat surface

10. Place multiplexer set and power cable in

such as a bench or table,

shipping container and prepare equipment for shipment.

perform only steps 4, 5, 9,

and 10 below.

Change 1 3-58