 |
|||
|
|
|||
|
Page Title:
MODEM CONTROLLER 1 PC CARD COMPONENT PERFORMANCE TEST |
|
||
| ||||||||||
|
|
 T.O. 31S5-4-308-l
TM 11-5805-633-14-13
NAVELEX 0967-464-0010
TTY LEV =
I/O PC card component performance test
perform the procedure in table 6-36.
i . Type in:
COMPONENT PERFORMANCE TEST. The
-
2(C/R)-
component performance test for the Modem
j . The TTY shall print out:
Controller 1 PC card is used to isolate
malfunctions to an IC or group of IC'S.
TTY ADD =
To accomplish the Modem Controller 1
PC card component performance test per-
k. Type in either:
form the procedure in table 6-3 7.
F930(C/R) for Switch Group
ATP test tape as follows:
F940(C/R) for ACOC Group
a . Open Program Maintenance Panel.
1. The TTY shall print out:
b. On Processor Auto-Load PC card
BTA = (YES = l, NO = O)
A1A3A9, set the four red toggle switches,
designated from top to bottom as S1 through
m. On Program Maintenance Panel:
S4, as follows: S1 and S2 to up position,
S3 and S4 to down position.
1. Enter hexidecimal 100 in address
line.
Mount and thread ATP tape on Mag
Tape Unit 1 (A1A1).
2. Enter hexidecimal 4004 in data
line.
d. On Mag Tape Unit, perform the
following:
n. Type in:
1. Press LOAD switch.
O(C/R)
2. When tape movement stops press
o. The TTY shall print out:
LOAD switch again.
3. When LOAD lamp is lighted, press
TST 01
ON LINE switch.
p. When TST 01 starts, immediately
press write switch in address line.
4. If LOAD lamp is not lighted after
the tape reel has made five or more revolu-
tions, press REWIND switch; then, when
q. Go to step 9 of table 6-37.
LOAD lamp lights, press ON LINE switch.
COMPONENT PERFORMANCE TEST (ACOC
e . Press reset and load switch.
GROUP ONLY). The component performance
test for the Printer Controller PC card is
f. When tape motion stops, repeat step
e eleven more times, to reach the twelfth
used to isolate malfunctions to an IC or
program. (Tape motion must come to a stop
group of IC's. To accomplish the Printer
after each load.)
Controller PC card component performance
test perform the procedure in table 6-38.
g . Press run switch.
h. The TTY shall print out:
ATP test tape as follows:
TTY TEST
a . Open Program Maintenance Panel.
6-351
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals