 |
|||
|
|
|||
|
Page Title:
BLOCK TRANSFER ADAPTER PC CARD COMPONENT PERFORMANCE TEST-CONT. |
|
||
| ||||||||||
|
|
 T.O. 31S5-4-308-l
TM 11-5805-633-14-13
NAVELEX 0967-464-0010
j . The TTY shall print out:
card component performance test perform
the procedure in table 6-34.
ADDR =
k. Type in:
ATP test tape as follows:
F8CO(C/R)
a. Open Program Maintenance Panel.
1. The TTY shall print out:
b. On Processor Auto-Load PC card
A1A3A9, set the four red toggle switches,
LVL=
designated from top to bottom as S1 through
S4, as follows: S1 and S2 to up position,
m. Type in:
S3 and S4 to down position.
3(C/R)
Mount and thread ATP tape on Mag
Tape Unit 1 (A1A1).
n. The TTY shall print out:
d. On Mag Tape Unit, perform the
# DRIVES =
following:
0 . Type in:
1. Press LOAD switch.
1(C/R)
2. When tape movement stops press
LOAD switch again.
The TTY shall print out:
p.
3. When LOAD lamp is lighted, press
UNIT =
ON LINE switch.
q. Type in:
4. If LOAD lamp is not lighted after
the tape reel has made five or more revolu-
tions, press REWIND switch; then, when
0(C/R)
LOAD lamp lights, press ON LINE switch.
r.
The TTY shall print out:
e . Press reset and load switch.
RD/WRT or WRT (1 or 0) =
f. When tape motion stops repeat step
S. Type in:
e twelve more times, to reach the thirteenth
program (tape motion must come to a stop
after each load).
1(C/R)
t . The TTY shall print out:
g . Press run switch.
h. The TTY shall print out:
SET DRV SLCT UNIT 0 = 0,
UNIT 1 = 1, ETC, PRS RUN
(BTA)
SUE MAG TAPE
TP
u. Depress run switch.
R/R ORC (1 or O)=
i . Type in:
v . The TTY shall print out:
1(C/R)
DFN TST PRMTRS (1 or 0) =
6-308
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals