 |
|||
|
|
|||
|
Page Title:
CM MIB PC CARD COMPONENT PERFORMANCE TEST |
|
||
| ||||||||||
|
|
 T.0. 31S5-4-308-l
TM 11-5805-663-14-13
NAVELEX 0967-464-0010
a. Open Program Maintenance Panel.
a. Open Program Maintenance Panel.
b. On Processor Auto-Load PC card
b . On Processor Auto-Load PC card
A1A3A9, set the four red toggle switches,
A1A3A9, set the four red toggle switches,
designated from top to bottom as S1 through
designated from top to bottom as S1 through
S4, as follows: S1 and S2 to up position,
S4, as follows: S1 and S2 to up position,
S3 and S4 to down position.
S3 and S4 to down position.
c. Mount and thread ATP tape on Mag
Mount and thread ATP tape on Mag
Tape Unit 1 (A1A1).
Tape Unit 1 (A1A1).
d. On Mag Tape Unit, perform the fol-
d. On Mag Tape Unit, perform the fol-
lowing:
lowing:
1. Press LOAD switch.
1. Press LOAD switch.
2. When tape movement stops press
2. When tape movement stops press
LOAD switch again.
LOAD switch again.
3. When LOAD lamp is lighted, press
3. When LOAD lamp is lighted, press
ON LINE switch.
ON LINE switch.
4. If LOAD lamp is not lighted after
4. If LOAD lamp is not lighted after
the tape reel has made five or more revolu-
the tape reel has made five or more revolu-
tions, press REWIND switch: then, when
tions, press REWIND switch; then, when
LOAD lamp lights, press ON LINE switch.
LOAD lamp lights, press ON LINE switch.
e. Press reset and load switches.
e. Press rest and load switches.
f. When tape motion stops, repeat step
f. When tape motion stops, repeat step
e four more times to reach the fifth program
e four more times to reach the fifth program
(GIN 4). Tape motion must stop after each
(GIN 4). Tape motion must stop after each
load.
load.
g. Press run switch after the fifth load.
Press run switch after the fifth load.
g.
NOTE
NOTE
A loop count will appear in bits 4 to
A loop count will appear in bits 4 to
15 and bit 2 will light to indicate
15 and bit 2 will light to indicate
GIN 4 is operating.
GIN 4 is operating.
h. Go to step 7 of table 6-24.
h. Go to step 7 of table 6-25.
FORMANCE TEST. The component perform-
FORMANCE TEST. The component perform-
ance test for the CM MIA PC card is used
ance test for the CM MIB PC card is used
to isolate malfunctions to an IC or group of
to isolate malfunctions to an IC or group of
IC'S. To accomplish the CM MIA PC card
IC's. To accomplish the CM MIB PC card
component performance test perform the pro-
component performance test perform the
cedure in table 6-25.
procedure in table 6-26.
ATP tape as follows:
ATP tape as follows:
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals