Rapid-Shift Negative Carrier

TM 11-405-10

Figure 22. Dustless negative carrier furnished with ES-20(1).

(f) Place the negative, emulsion (dull)

(f) Mask any area of the aperture not

side down, on the glass in the lower

covered by the negative.

plate.

Mask any area of the

(g) Place the thick glass plate over the

aperture not covered by the

negative.

(h) Fasten the thick glass plate with the

(g) Position the upper plate on the lower

spring clips.

plate by matching the locating studs

c. Rapid-Shift Negative Carrier. The rapid shift

with the holes in the upper plate.

negative carrier is used with 35-mm roll film. When a

(2) ES-20(1) (fig. 24).

single cut frame of 35-mm film is to be enlarged (par.

(a) Turn the spring clips to release the

26), use the glass negative carrier.

glass plates.

(1) PH-406 (B, fig. 21).

(b) Remove both glass plates from the

(a) Hold the rapid-shift negative carrier

holder.

so that the concave side of the film

holder faces upward.

above).

(b) Insert the end of the film roll,

(d) Replace the thin glass plate in the

emulsion side down, into one end of

holder.

the film channel.

(e) Place the negative, emulsion side

down, on the thin glass plate.

AGO 5894A