REASSEMBLY - TM-11-3895-209-140058

TM 11-3895-209-14

5-9. DISASSEMBLY AND REASSEMBLY OF TIMING BELT IDLER ASSEMBLY- Continued

D Remove the idler arm spring (16).

E Remove the two nuts (1) and (4) and lock washers (2) and (5) from the idler (7).

F Remove the idler shaft (7) from the idler arm (15) and remove the two inner collars (3) and (6),

outer collar (10), and ball bearing (9) from the idler shaft.

G Remove the retaining ring (8), and slide the ball bearing out of the outer collar (10).

Z REASSEMBLY

A Insert the ball bearing (9) into the outer collar (10), and install the retaining ring (8).

B Slide the idler shaft (7) into one side of the idler arm (1 5), and install the inner collar (3), ball

bearing (9), outer collar (10), and inner collar (6), while pushing the idler shaft through the arm.

C Install and tighten the two lock washers (2) and (5) and the nuts (1) and (4) on the idler shaft.

D Place the idler arm spring (16) on the spring seat on the idler base (24). Position the arm against

the spring and aline it with the holes in the base.

E Install the washer (13) on the clevis pin (14), and insert the clevis pin through the idler base (24)

and the idler arm (15).

F Install the washer (12) and cotter pin (11).

G Place the idler assembly on the frame of the RL-207(*)/G and aline the holes in the base with

the holes in the frame.

H Install and tighten the bolt (21), lock washer (22), and nut (23).

I Install and tighten the mounting bolt spacer (18), bolt (17), lock washer (19), and nut (20).

5-10. DISASSEMBLY AND REASSEMBLY OF BEARING HOUSING ASSEMBLY

DISASSEMBLY

A Remove the axle shaft,

B To remove the bearing housing assembly from the frame, remove the four bolts (19), nuts (21),

lock washers (20), and lift the assembly off the frame.

C Remove the socket-head capscrew (5), and then remove the lock bolt assembly (6), (7), and (8).

Remove the ball bearing (3) and latch spring (4), from the lower unit.

NOTE

In the upper unit, the latch spring and ball bearing are installed under the locking plate.

In the lower unit, the latch spring and ball bearing are installed under the lock bolt

assembly.

D Disassemble the lock bolt assembly; remove the E-ring (6) and the locknut (7) from the lock bolt

(8).

E Remove the socket-head capscrew (1), and locking plate (2). Remove the ball bearing (3) and

the latch spring (4) from the upper unit.

5-6