REMOVAL AND REPLACEMENT IGNITION SWITCH

TM 11-3895-209-14

4-13. REMOVAL AND REPLACEMENT OF THROTTLE CONTROL - Continued

D Pull the end of control wire out of the hole in throttle lever.

E Remove nut (9) and lock washer (10) from shaft of THROTTLE control rod (11).

F Pull the THROTTLE control rod (11) out through the hole in the control panel.

REPLACEMENT

A Replace THROITLE control rod through hole in control panel.

B Replace nut (9) and lock washer (10) on shaft of THROTTLE control rod (11).

C Replace the end of control wire in hole of throttle lever.

D Replace nut (5), lock washer (6), screw (4), and choke and throttle clamp (7).

E Replace nut (2), lock washer (3), screw (1), and clamp (12).

NOTE

To adjust the THROTTLE control, push the THROTTLE control rod (11) to its innermost

position. Position the throttle lever on the engine outward against the stop and then

tighten setscrew (8).

4-14. REMOVAL AND REPLACEMENT IGNITION SWITCH

REMOVAL

A Open guard door and remove cover

from the engine accessory case

(TM 5-2805-257-1 4).

B Remove cover from engine accessory

case (TM 5-2805-257-14).

C Disconnect the two IGNITION switch

wires from the magneto terminals and

pull the wires out through the grommet

4-12