Section Ill. LUBRICATION

TM 11-3895-209-14

4-4. INSTALLATION ON VEHICLE-Continued

D Check the alirgement of the holes in the chassis of the RL-207(*)/G and the holes drilled in the

bed of the truck body. Use a driftpin to aline the holes.

E Secure the RL-207(*)/G in position with a 1/2-20 by 2 1/2-inch bolt at each of the four holes.

Section Ill. LUBRICATION

4-5. GENERAL

Lubrication schedules and lubrication instructions are given in chapters 3 and 4.

Lubrication information for the engine is given in TM 5-2805-257-14. Follow the procedure given

below to drain the engine crankcase:

Remove the lower reel axle.

Release the fasteners on the engine guard door, and open the door.

NOTE

Start the engine and allow it to run long enough to warm up thoroughly before dr

t h e engine crankcase.

Remove the drain hose from the two spring clips, and place the end of the hose clear of the equip-

ment and vehicle. Use a container to catch the used oil when the valve is opened.

Turn the handle of the drain valve outward (perpendicular to the engine) to permit the oil to drain out

through the hose,

When the crankcase is thoroughly drained, close the valve.

Refill the crankcase with the OE-30 lubricant.

4-4