|
|
TB 9-2350-257-20-1
STEP 2
NOTE
Use only Multimeters TS-352 B/6,
To ensure overvoltage protection circuit breaker on the
AN/URM-105, or approved equivalents
voltage regulator is in the ON (UP) position, turn the
for
all
voltage
and
overvoltage circuit breaker to the OFF (DOWN) position,
measurements in this procedure
then to the ON (UP) position, before performing further
tests Connect "T" harness to regulator.
Check continuity from socket C of the test harness to
vehicle chassis (GROUND)
a. If continuity exists, proceed to step 3.
b. If continuity does not exist, repair harness
11673835 (GROUND).
8
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |