Figure 4-27. Template fabrication

TB 9-2300-378-14

Figure 4-27. Template fabrication

Using rule and scribe, scribe left and right vertical guide bars as indicated (view

(5)

B).

Tape c a r d b o a r d to air outlet port to prevent cutting and grinding debris from

(6)

entering engine.

WARNING

Use approved eye protection during grinding operations to

prevent serious eye injury.

Using hand grinder with cutting wheel, cut along scribed lines through vertical

(7)

guide bar.

Cut through weld on backside of guide bar between cut-off line and lower end of

(8)

bar.

Replace cut-off wheel with grinding wheel and remove remaining weld in cut-off

(9)

area.

(lo)

Using rags and vacuum cleaner, remove cutting and grinding operation debris.

(11)

Prime and paint bare metal areas.

(12)

After paint has dried, wipe and vacuum inside of air cleaner housing to remove

paint overspray residue.

(13)

Remove cardboard and tape from air outlet port.

(14)

Inspect door seal. Replace if defective (TM-20).

(15)

Install air cleaner filter element (TM-20).

4-52