PANELS- REPLACE

TM 10-4930-233-14

TM 4930-14/1

ENCLOSURE AND SKID ASSEMBLY

5-4. PANELS- REPLACE

This task covers:

a. Removal

b. Installation

INITIAL SET-UP:

Materials/Parts

Equipment Condition

Tools

Epoxy-polymide primer

Enclosure Assembly Removed

Drill with 3/16 Drill Bits

coatings (Item 13 App.E)

(Section III, Item 2, App B)

Synthetic rubber caulking

compound (Item 4, App.E)

a. Removal.

NOTE

Step 2 applies to all panels. For other steps, proceed only as needed.

(1) For top panel removal, drill out all rivets (1) and remove eight hooks (2).

(2) For all panels, drill out rivets (3) around outside edge and remove panel (4).

(3) For front and rear side panels, drill out four rivets (5) and remove handle (6).

(4) For near right side panel, drill out nine rivets (7) and remove storage pocket (8).

Change 1

5-12.1