Reassembly of Planet Carrier (CONT) - TM-5-3895-349-14-P0727

14. Secure spindle and brake spider to axle housing with

17. Seat felt grease retainer in recess in brake spider.

bolts, lockwashers, and nuts and tighten to specified

Install retaining ring in retaining ring groove. (Fig.

torque (Fig. 169).

172).

15. Tap brake camshaft bushing into brake spider (Fig.

170).

18. Position air chamber bracket and spacers, which were

previously installed, so that there is no binding be-

tween cam shaft and air chamber bracket bushing.

Tighten bracket mounting bolts to specified torque

(Fig. 173).

19. Position slack adjuster on cam shaft. Secure with re-

taining ring and washer (Fig. 174). Be sure to in-

stall slack adjuster so that adjusting screw points in

same direction as before disassembly. In some appli-

cations adjusting screw is adjacent to air chamber

16. Position thrust washer and "O" ring on brake cam

bracket. In others it is as shown in Fig. 174.

shaft. Insert cam shaft through bushing in brake

spider and position felt grease retainer, grease

washer, and retaining ring on cam shaft (Fig. 171).