Special Information. - TM-5-3740-214-24P0007

TM 5-3740-214-24P

Recoverability

Code

Definition

Nonreparable item. When unserviceable, condemn and dispose at the level indicated in position 3.

Reparable item. When uneconomically reparable, condemn and dispose at organizational level.

Reparable item. When uneconomically reparable, condemn and dispose at the direct support level.

Reparable item. When uneconomically reparable, condemn and dispose at the general support level.

Reparable item. When beyond lower level repair capability, return to depot. Condemnation and disposal not

authorized below depot level.

L Reparable item. Repair, condemnation, and disposal not authorized below depot/specialized repair activity

level.

A Item requires special handling or condemnation procedures because of specific reasons (i.e., precious metal

content, high dollar value, critical material or hazardous material). Refer to appropriate manuals/directives for

specific instructions.

c. National Stock Number. Indicates the National stock number assigned to the item and will be used for

requisitioning purposes.

d. Part Number. Indicates the primary number used by the manufacturer which controls the design and

characteristics of the item by means of its engineering drawings, specifications, standards, and inspection requirements

to identify an item or range of items.

NOTE

When a stock numbered item is requisitioned, the repair part received may have a different part

number than the part being replaced.

e. Federal Supply Code for Manufacturer (FSCM). The FSCM is a 5-digit numeric code listed in SB 708-42

which is used to identify the manufacturer, distributor, or Government agency; etc.

f Description. Indicates the Federal item name and, if required, a minimum description to identify the item.

Items that are included in kits and sets are listed below the name of the kit or set, with the quantity of each item in the kit

or set indicated in the quantity incorporated in unit column. When the part to be used differs between serial numbers of

the same model, the effective serial numbers are shown as the last line of the description. In the Special Tools List, the

initial basis of issue (BOI) appears as the last line in the entry for each special tool, special TMDE, and support

equipment. When density of equipments supported exceeds density spread indicated in the basis of issue, the total

authorization is increased accordingly.

g. Unit of Measure (U/M). Indicates the standard of the basic quantity of the listed item as used in performing the

actual maintenance function. This measure is expressed by a two-character alphabetical abbreviation (e.g., ea, in., pr,

etc.). When the unit of measure differs from the unit of issue, the lowest unit of issue that will satisfy the required units of

measure will be requisitioned.

h. Quantity Incorporated in Unit. Indicates the quantity of the item used in the breakout shown on the illustration

figure, which is prepared for a functional group, subfunctional group, or an assembly. A "V" appearing in this column in

lieu of a quantity indicates that no specific quantity is applicable (e.g., shims, spacers, etc.).

4. Special Information.

a. Repair parts kits and gasket sets appear as the last entries in the repair parts listing for the figure in which its

parts are listed as repair parts or are listed at the end of the repair parts listing for the last figure containing parts of the

kit.

b. In the parts list, some items are indented to show that they are a component or components of the item under

which they are indented.

c. The following publication pertains to the ULV Aerosol Generator and its components:

Publication and Short Title

TM 5-3740-214-14

ULV Aerosol Generator

5. How to Locate Repair Parts.

a. When National Stock Number or Part, Number is Unknown: