CLEANING, INSPECTION AND REPAIR - TM-5-3655-214-13-P0041

TM 5-3655-214-13&P

4-9. GUARDS - Continued

LOCATION/ITEM

ACTION

REMARKS

REMOVAL

1. Guard.

(continued)

d. Remove belt guard

WARNING

Dry cleaning solvent, P-D.680 or P-S-661, used to clean parts is potentially dangerous to personnel and property. Use in

a well-ventilated area as the fumes are dangerous if inhaled. Avoid repeated and prolonged skin contact. Do not use

near open flame or excessive heat. Flash point of solvent is 100F.- 138F (38C.-59C.)

CLEANING, INSPECTION AND REPAIR

a. Clean all parts in an approved cleaning

solvent and dry with a clean, lint-free

cloth or compressed air.

b. Inspect screws and nuts for damaged

threads.

Inspect guards for cracks and obvious

damage.

d. Replace defective parts as required.

INSTALLATION

a. Refer to illustration at the end of this

section, and install belt guard (8) on

skid base.

b. Install six screws (5), six flat washers

(6) and six lock-washers (7) to attach

belt guard (8).

Install two screws (1), two flat washers

(2) and two lock-washers (3) to attach

pump guard (4).

4-9