UUT testing

TM 32-5865-069-24&P

(3) Load the ATESP from magnetic tape to the removable disk by entering

the following commands at the keyboard:

DIR DP0 ret

INIT MT0 ret

LOAD/A/V MT0: 0 (file names from table 5-1, one space between

each name) ret

LOAD/A/V MT0: @ 05051630PV1.IC 5051630ADP.IC 5051630SRV.IC ret

example:

NOTE

When more than three file names are used, enter three file names

followed by the

character and a carriage return, then the remaining

file names.

(4) Verify that all the file names required are displayed on the Video

Display Terminal (VDT).

(5) Enter the following command at the keyboard:

RELEASE MTO ret

(6) Remove the ATESP magnetic tape in accordance wih the instructions

detailed in PDEP 11-6625-2773-12-3.

UUT testing:

(1) At the Test Operator's Panel Select; the desired interface(s)

(printer, disk, etc.); the desired test result output (ALL TESTS or

FAILURES ONLY) .

NOTE

If no selection is made, no test results will be saved.