|
|
TM 32-5410-215-14&P
CHAPTER 4
OPERATOR/CREW MAINTENANCE INSTRUCTIONS
4-1 GENERAL. Operator/Crew maintenance is limited to initial inventory and visual inspection during operation.
CHAPTER 5
ORGANIZATIONAL MAINTENANCE INSTRUCTIONS
Section I. TOOLS AND EQUIPMENT
5-1 TOOLS AND TEST EQUIPMENT. Tools and test
5-3 MATERIALS. Materials required are listed in
equipment required are listed in Appendix D of this
manual. There are no special tools or test equipment
materials required.
required.
5-2 REPAIR PARTS. Repair parts required are listed
and illustrated in Appendix E of this manual.
Section II. REPAINTING AND REFINISHING INSTRUCTIONS
stowage facilities (RPSF) will be according to TB 43-
CAUTION
0118, Field Instructions for Painting and Preserving
Electronics Command Equipment Including Camouflage
Do not paint the typewriter, plastic
Pattern Painting of Electrical Equipment Shelters. Paints
surfaces or electrical switches and
and finishes will be according to SB 11-573, Painting and
contacts.
Preservation Supplies Available for Field Use for
Electronics Command Equipment, and AR 746-1,
5-4 REPAINTING, REFINISHING AND RETOUCHING.
Packaging of Army Materiel for Shipment and storage.
Repainting, refinishing and retouching of the repair parts
Section III. LUBRICATION INSTRUCTIONS
a. Shelter Door. Apply a light film of oil, item 9,
5-5 GENERAL. There is no lubrication order for the
RPSF. Lubrication is limited to the sliding and rotating
b. Chair and Tiedown Assembly. Apply a light film
parts listed below. These parts should be checked and
of oil, item 9, Appendix F, to the chair adjusting screw
lubricated as required quarterly. Checks should be more
and inside the chair tiedown pin sliding collar (figure 3-1).
often if operating under unusual conditions. Refer to the
c. Drawer Slides. Apply a light film of dry graphite,
commercial manual for lubrication of the typewriter.
item 8, Appendix F, to all drawer slides.
4-1/5-1
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |