APPENDIX E REPAIR PARTS AND SPECIAL TOOLS LIST

TM 32-5410-215-14&P

APPENDIX E

REPAIR PARTS AND SPECIAL TOOLS LIST

Section I. INTRODUCTION

E-1 SCOPE. This appendix lists spares and repair

Code

Definition

parts; special tools; special Test, Measurement, and

Diagnostic Equipment (TMDE), and other special support

Item procured and stocked for anticipated or

equipment required for performance of organizational,

known usage.

direct support, and general support maintenance of the

Repair Parts Stowage Facilities AN/USM-378, AN/USM-

Item to be manufactured or fabricated at

379 and AN/ USM-380 (RPSF). It authorizes the

organizational level.

requisitioning and issue of spare and repair parts as

indicated by the source and maintenance codes.

Item is not procured or stocked.

If not

available through salvage, requisition.

E-2 GENERAL. This Repair Parts and Special Tools

List is divided into the following sections:

A support item that is not stocked. When

required, item will be procured through normal

a. Section II. Repair Parts List. A list of spares

support channels.

and repair parts authorized for use in the performance of

maintenance. The list also includes parts which must be

NOTE:

removed for replacement of the authorized parts. Parts

lists are composed of functional groups in numeric

sequence, with the parts in each group listed in figure

Cannibalization or salvage may be

and item number sequence. Bulk materials are listed in

used as a source of supply for any

National Stock Number (NSN) sequence.

items coded above except those

b. Section III. Special Tools List. Not applicable.

coded XA and aircraft support items

c. Section IV. National Stock Number and Part

as restricted by AR 70042.

Number Index. A list, in National Item Identification

Number (NIIN) sequence, of all National Stock Numbers

(2) Maintenance Code. Maintenance codes

(NSN) appearing in the listings, followed by a list in

are assigned to indicate the levels of maintenance

alphanumeric sequence of all part numbers appearing in

authorized to USE and REPAIR support items. The

the listings. National stock numbers and part numbers

maintenance codes are entered in the third and fourth

are cross reference to each illustration figure and item

positions of the uniform SMR code format as follows:

number appearance.

(a) The maintenance code entered in

E-3 EXPLANATION OF COLUMNS.

the third position will indicate the lowest maintenance

level authorized to remove, replace, and use the support

a. Illustration. This column is divided as follows:

item. The maintenance code entered in the third position

will indicate one of the following levels of maintenance:

(1) Figure Number.

Indicates the figure

number of the illustration on which the item is shown.

Code

Application/Explanation

(2) Item Number.

The number used to

Support item is removed, replaced, used at the

identify item called out in the illustration.

organizational level.

b. Source, Maintenance, and Recoverability (SMR)

(b) The maintenance code entered in

Codes.

the fourth position indicates whether the item is to be

repaired and identifies the lowest maintenance level with

(1) Source Code. Source codes indicate the

the capability to perform complete repair; i.e., all

manner of acquiring support items for maintenance,

authorized maintenance functions. This position will

repair, or overhaul of end items. Source codes are

contain one of the following maintenance codes:

entered in the first and second positions of the uniform

SMR code format as follows:

E-1