REASSEMBLY (CONT) - TM-3-4230-209-30-P0229

Machine screw (12)

Insert machine screw (12) through lock washer (13), flat washer (14), and

Lock washer (13)

into distributor contact set (4). Then screw into the mounting plate. Do not

Flat washer (14)

tighten fully.

Rotate the shaft (15) while watching the cam (16) turn until the distributor

Shaft (15)

Cam (16)

contact set breaker arm is riding on the highest point of the cam (16).

Using a feeler gage inserted in the distributor contact set points, move the

stationary support bracket of the contact set until a gap clearance of

0.015 to 0.018 inch is obtained. Using the proper tool, tighten machine

screws (9 and 12). Recheck the gap clearance to make sure the station-

ary support bracket did not move.

q PART OF DISTRIBUTOR CONTACT SET

2-213

TM 3-4230-209-30&P