REASSEMBLY - TM-3-4230-209-30-P0228

TM 3-4230-209-30&P

2-212

2-46. COMBUSTOR MAGENTO (CONT).

REMARKS

ACTION

LOCATION/lTEM

Combustor Magneto/

Replace authorized unserviceable parts.

Repair ignition distributor cap (1) by replacing ignition terminal sleeve (2).

Ignition distributor cap (1)

Ignition terminal sleeve (2)

Minor pitting of distributor contact set (3) points may be repaired by using

Distributor contact set (3)

crocus cloth. Care must be taken to make sure that contact point face

surfaces are flat and that all the face surfaces contact squarely.

Combustor Magneto/

Fixed capacitor (1) and distributor contact set (4) are

Position fixed capacitor (1) onto the mounting plate. Insert machine

Fixed capacitor (1)

component parts of the ignition magneto parts kit.

screw (2) through lock washer (3) and fixed capacitor (1). Screw into the

Machine screw (2)

mounting plate and tighten.

Lock washer (3)

Distributor contact set (4)

Assemble distributor contact set (4) by connecting the wires from the

Machine screw (5)

magneto and fixed capacitor (1) to distributor contact set (4) with machine

Flat washer (6)

screw (5), flat washer (6), and nut (7). Tighten the screw connecting the

Nut (7)

wires to distributor contact set (4).

Position distributor contact set (4) onto the mounting plate and install

Retaining ring (8)

retaining ring (8). Insert machine screw (9) through lock washer (10), flat

Machine screw (9)

washer (11), and into distributor contact set (4). Then screw into the

Lock washer (1O)

mounting plate. Do not tighten fully.

Flat washer (11)