REASSEMBLY (CONT) - TM-3-4230-209-30-P0180

2-164

TM 3-4230-209-30&P

2-33. LIQUID FUEL WATER HEATER AND CABINET TOP COVER (CONT).

LOCATION/lTEM

ACTION

REMARKS

REASSEMBLY (CONT)

Liquid Fuel Water Heater and

Cabinet Top Cover/

Loop clamp (19)

CAUTION

Internal tooth lock

Do not bend or kink capillary tubes. Bends shall have a

washer (20)

radius of 6 inches to prevent kinks. Any damage requires

Machine screw (21)

replacement.

Slide loop clamp (19) around capillary tubes and electrical wires. Position

loop clamp (19) so it alines with screw hole in the upper inboard part of

the control box (9). Install internal tooth lock washer (20) and machine

screw (21). Repeat for lower loop clamp holding wires running downward

from control box (9).

Electrical tiedown strap (22)

Starting at the control box end of the wire bundle, install electrical tiedown

straps (22) along entire length of electrical wires and capillary tube about

four inches apart. Do not pull the electrical tiedown straps so tight that

they smash the capillary tubes.

Access cover (23)

Position access cover (23) onto front of the boiler assembly (1) and

Internal tooth lock

secure with three internal tooth lock washers (24) and hexagon plain

washers (24)

nuts (25).

Hexagon plain nuts (25)

Nonmetallic grommet (26)

Slide nonmetallic grommet (26) around electrical wires and capillary tubes

and slide nonmetallic grommet into the notched area of access cover (23).