REASSEMBLY (CONT) - TM-3-4230-209-30-P0114

2-98

TM 3-4230-209-30&P

2-21. PLUMBING ASSEMBLY (CONT).

LOCATION/lTEM

ACTION

REMARKS

Pipe nipple (30)

Using antiseizing tape or sealing compound, wrap or coat the external

Pipe elbow (31)

threads of pipe nipple (30) and eductor (34).

Screw pipe nipple (30) and pipe elbow (31) together; then, as a unit, screw

into the centrifugal pump (8). Tighten until the open end of pipe elbow (31)

is pointing straight back.

Eductor (34) must extend at least two inches through

Pipe nipple (32)

Screw pipe nipple (32), pipe reducer (33), and eductor (34) together; then,

as a unit, screw into pipe elbow (31). Tighten pipe nipple (32), pipe

the connector panel. If it does not, use pipe

Pipe reducer (33)

nipple (32).

reducer (33), and eductor (34).

Eductor (34)

Position the side outlet so it is pointing upward.

Metallic pipe (35)

Using antiseizing tape or sealing compound, wrap or coat the external

Pipe elbow (36)

threads of metallic pipe (35), pipe nipple (37), and pipe to hose straight

Pipe nipple (37)

adapter (39).

Ball valve (38)

Pipe straight adapter (39)

Screw metallic pipe (35) and pipe elbow (36) together; then, as a unit,

screw into the centrifugal pump (8) drain hole.

Tighten and position the open end of pipe elbow (36) so that it is pointing

forward and horizontal.

Screw pipe nipple (37), ball valve (38), and pipe straight adapter (39)

together; then, as a unit, screw into pipe elbow (36).