REASSEMBLY (CONT) - TM-3-4230-209-30-P0104

TM 3-4230-209-30&P

2-88

2-20. SKID BASE SUBASSEMBLY (CONT).

REMARKS

ACTION

LOCATION/ITEM

Skid Base Subassembly/

WARNING

Unless it is securely blocked, never reach under the skid

base subassembly while it is raised off the floor. Failure to

comply may result in a crushed arm.

Raise and block skid base subassembly in accordance with local policy.

Position generator support (50) onto skid over the two holes near center

Generator support (50)

and insert two hexagon head cap screws (51 ) through flat washers (52),

Hexagon head cap

terminal on ground wire (53) generator support (50), and the skid.

screws (51)

Flat washer (52)

Ground wire (53)

Reach under skid and install two internal tooth lock washers (54) and

Internal tooth lock

hexagon plain nuts (55) to secure.

washer (54)

Hexagon plain nut (55)

NOTE

Final adjustment of generator

support (50) will be required

after the alternator-generator

V belts have been installed.

The mount will have to be

adjusted so V belt will track

correctly in the pulley groove.

A misalined mount will cause

belt to be thrown off of pulley

or cause excessive wear on

belts.