 |
|||
|
|
|||
|
Page Title:
FUEL PUMP AND IGNITION DRIVE MOTOR WILL NOT START WITH HEATER CONTROL SWITCH IN HEATER ON POSITION (CONT). |
|
||
| ||||||||||
|
|
 Step 9. Check wire No. 10 for continuity using the following procedures:
a. Disconnect wire No. 10 from switch S4, terminals 1 and 5.
b. Use multimeter to check continuity between ends of wire No. 10 while flexing along its entire length.
Reinstall wire No. 10 to switch S4, terminals 1 and 5, if continuity is indicated.
Replace wire No. 10 on switch S4 between terminals 1 and 5 with new wire if anything other than continuity is indicated.
2-19
TM 3-4230-209-30&P
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals