APPENDIX B DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

TM 3-1040-220-34&P

APPENDIX B

DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

REPAIR PARTS AND SPECIAL TOOLS LIST

Section I lNTRODUCTlON

B-1. Scope

(1) Source Code. Source codes are assigned to

This appendix lists repair parts; and other support

support items to indicate the manner of acquiring support

equipment required for operation and performance of

items for maintenance, repair, or overhaul of end items.

direct support and general support maintenance of the

Source codes are entered in the first and second

M5 Helicopter-or-Vehicle-Mounted Riot Control Agent

positions of the Uniform SMR Code format as follows:

Disperser and authorizes the requisition and issue of

items as indicated by the source and maintenance

Code

Definition

codes.

Item procured and stocked for anticipated or

B-2. General

known usage.

This Repair Parts and Special Tools List is divided into

PB-

Item procured and stocked for insurance

the following sections:

purpose because essentially dictates that a minimum

quantity be available in the supply systems.

a. Section II-Repair Parts List. A list of repair parts

KF-

An item of a maintenance kit and not purchased

authorized for use in the performance of maintenance.

separately.

Maintenance kit defined as a kit that

The list also includes parts which must be removed for

provides an item that can be replaced at organizational

replacement of the authorized parts. Parts lists are

or intermediate levels of maintenance.

composed of functional groups in ascending numerical

Item to be assembled at organizational level.

sequence, with the parts in each group listed in figure

XA-

Item is not procured or stocked because the

and item number sequence.

requirements for the item will result in the replacement of

b. Section III-Special Tools List. Not applicable.

the next higher assembly XB-1tem is not procured or

stocked. If not available through salvage. requisition.

c. Section IV-National Stock Number and Part limber

Index. A list, in ascending numerical sequence, of all

NOTE

National stock numbers appearing in the listings,

Cannibalization or salvage may be used

followed by a list, in alphameric sequence, of all part

as a source of supply for any items

numbers appearing in the listings.

National stock

source coded above except those coded

number and part numbers are cross-referenced to each

XA, XD, and aircraft support items as

illustration figure and item number appearance. This

restricted by AR 700-42.

index is followed by a cross-reference list of reference

designations to figure and item numbers when

(2) Maintenance Code. Maintenance codes are

applicable.

assigned to indicate the levels of maintenance

authorized to USE and REPAIR support items. The

B-3. Explanation of Columns

maintenance codes are entered in the third and fourth

The following provides an explanation of columns found

positions of the Uniform SMR Code format as follows:

in the tabular listings:

(a) The maintenance code entered in the third

a. Illustration. This column is divided as follows:

position will indicate the lowest maintenance level

(1) Figure Number. Indicates the figure number

authorized to remove, replace, and use the support item.

of the illustration in which the item is shown.

The maintenance code entered in the third position will

(2) Item Number. The number used to identify

indicate one of the following levels of maintenance:

each item called out in the illustration.

Code

Application

b. Source, Maintenance and Recoverability

Explanation

Codes (SMR).

C-

Crew or operator maintenance performed

within organizational maintenance.

O-

Support item is removed, replaced, used at the

organizational level.

F-

Support item is removed, replaced, used at the

direct

support level

H-

Support item is removed, replaced, used at the

general support level.

B-1