Click here to make tpub.com your Home Page

Page Title: GENERAL:
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

MAINTENANCE:
STEERING  SYSTEM  PRESSURE  TESTING  AND
Steam is recommended as the most effective method but
ADJUSTMENT should be made every 400 hours after
if unavailable, use a spray of mineral spirits or similar
machine  operation  with  hydraulic  oil  at  operating
solvent which is non-harmful to hoses or exposed
temperature. Park machine on level ground, set parking
electrical harnesses.
brake and lower blade. Remove top bulkhead cover and
rear floor plate. Install a 3000 psi pressure gauge in test
INSPECT WIRING HARNESSES and connections for
port on bottom of steering relief valve. With engine RPM
loose or damaged connections, chafed wire, etc.
at 2000, check steering relief pressure by turning machine
to a full lock (fully turned) position and taking gauge
reading.
800 Hours:
ENGINE:
DRAIN AND FLUSH RADIATOR every 800 hours or twice
yearly. Remove thermostat and reverse flush the system.
Refill to within 1/2 inch (1,5 cm) below bottom of fill-pipe
with required combination of anti-freeze (with rust
Steering System Pressure Test
inhibitor) and clean water.
Note: Do not use 'DOWTHERM 209'.
Caution: Do not hold for more than 30 seconds. If
pressure is more than 50 psi (345 kPa,3,5 kg/sq. cm)
above or below 2000 psi (13780 kPal140 kg/sq. cm), the
steering relief valve should be adjusted (refer to
SERVICE MANUAL
for detailed instructions).
GENERAL:
CHECK AND ADJUST ALL CONTROL LEVERS,
LINKAGES AND CABLES. Inspect and lubricate all
mechanical controls to make sure they are in good
operating condition.
STEAM  CLEAN  MACHINE  every  400  hours  or
Radiator
periodically as required. Dirt accumulation may become
detrimental to machine operation. Protect alternator and
starter motor by covering them before steam cleaning.
Rev.760501
400-4.12
K300

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business