AXLES: - TM-5-3895-349-14-P0833

MAINTENANCE:

CHECK ANTI-FREEZE protection. Maintain readings well

INSPECT AIR INLET CONNECTIONS for leaks or damaged

below anticipated temperatures, adding permanent type

tubing. If air by-passes the air filter and enters directly into

anti-freeze with rust inhibitors as required. Do not use

the engine, serious damage may result.

anti-freeze with anti-leak additives.

Do not use

'Dowtherm 209'

TRANSMISSION:

STEAM CLEAN RADIATOR every 50 hours or as

required to maintain optimum cooling efficiency. The

OIL AND FILTER CHANGE should be made after initial 50

importance of a clean radiator cannot be overstressed.

hours of operation, and there- after filter change every 200

Remove air-oil cooler leaving hoses connected. Clean

hours and oil and filter change every 400 hours.

carefully and inspect core for bent or damaged fins.

Transmission oil should be at operating temperature.

Remove sump screen, cleaning thoroughly and replace

using new gaskets. Access to the filter can be made by

removing rear floor plate' and seat mounting base, complete

with seat. Using a chain or belt filter wrench, remove

canister. Remove old element and check for foreign

material deposits. Install new element and O ring. Install

filter canister and torque to 20 to 25 ft-lbs (2,8 to 3,5 m-kg).

Refill transmission to FULL mark (refer to LUBRICANTS

SPECIFICATION CHART ). Idle engine to prime converter

and lines and recheck level, topping to FULL mark as

required. When oil temperature is at operating temperature

of 180 to 200 (82 to 93 ) make final oil level check.

AXLES:

CHECK DIFFERENTIAL AND PLANETARY OIL LEVELS

after machine operation but allow 5 minutes for all the oil to

drain to its normal level. Planetary oil level is checked at

Hinged Air-Oil Cooler

filler plug on planetary end cap with filler hole at its lowest

position, and differential oil level is checked at filler plug on

INSPECT RADIATOR HOSES and connections for leaks

differential housing. Add lubricant as necessary (refer to

or damaged hoses.

LUBRI- CANTS SPECIFICATION CHART).

CHANGE OIL after initial 50 hours of operation with oil at

operating temperature. Subsequent changes are made

every 800 hours. Remove plug at bottom of axle housing

and allow lubricant to drain. Replace drain plugs and fill

with a light flushing oil. Operate axles for a short period of

time, then drain. Inspect the magnetic drain plug for foreign

particles indicative of wear or possible failure. Replace

drain plugs

Radiator Hose Connections

K300

Rev. 760501

400-4.4