Click here to make tpub.com your Home Page

Page Title: DISASSEMBLY:
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

BRAKE CONTROL:
High Pressure Piston Removal
Relief Valve Removal
DISASSEMBLY:
1. Place master cylinder in a vise in horizontal
position.
2. Remove the cover plug, then remove the relief
valve by turning it counter-clockwise. The valve cylinder
is slotted on the top edge to fit a wide screwdriver.
Low Pressure Piston Removal
ASSEMBLY:
1. Place the cylinder in horizontal position in a vise.
Note: To prevent damaging the cups, be sure to lubricate
the high pressure, low pressure and secondary cups with
transmission
fluid
[refer
to
SPECIFICATION CHART.
2. Replace the low pressure piston.
End Plug Removal
3. Replace first the small and then the large return
springs.
3. Remove the end plug. This nut is under spring
4. Insert the inside end plug gasket.
pressure. The high pressure piston, end plug gasket and
5. In order to properly assemble the unit, it is
check valve assembly should "pop" out on the release of
essential to push the low pressure piston forward about
the end plug.
11/2 inches (4 cm) from the pushrod end with a rod or
4. The low pressure piston may be removed by
screwdriver and to hold the piston in this position until the
pushing the piston through the cylinder from the pushrod
high pressure piston has been installed.
end.
Rev. 760501
K300
70-1.3

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business