Click here to make tpub.com your Home Page

Page Title: REASSEMBLY (CONT)
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

The unit is now ready to be returned to service.
and evenly to 150 inch pounds torque. Figure No. 54.
Check the condition of the column assembly, clean it,
and replace on the unit with two cap screws oriented as
before.  Rotate the steering shaft while bringing the
surfaces into contact to allow splines to engage. Figure
No. 55. If in
doubt, follow the orientation as shown. Tighten cap screws
to 280 inch pounds. Figure No. 56.
To service earlier units, follow a similar procedure. In
units with a hat-shaped check plug, use gasket No. 20911
between the housing and the mounting plate. Insure that
each part is smooth and clean by rubbing on 400 grit
abrasive paper before cleaning for reassembly.
In units which have thin plastic gaskets at the meter
section seams a gasket MUST be used at each side of the
ring gear unless the entire gear set is replaced.
Replacement gear sets are sized so that the gasket should
NOT be used.
PAGE 16

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business