REASSEMBLY (CONT)

is not cocked and install four mounting plate cap screws.

Place the plate over this assembly so that the bolt

Tighten these evenly and gradually to a torque setting of

holes in the plate align with the tapped holes in the

250 inch pounds. Figure No. 43.

housing. Figure No. 46. Place the meter

Reposition in vise and clamp across the edges of the

gear ring on the assembly so that the bolt holes align.

mounting plate. Check to insure that the spool and sleeve

Figure No. 47.

are flush or slightly below the 14 hole surface of the control

housing. Figure No. 44.

Place the splined end of the drive within the meter

Clean the upper surface of the housing by wiping with

gear star so that the slot at the control end of the drive is in

the back of a clean hand or the butt of the thumb. Clean

alignment with the valleys between the meter gear teeth,

each of the flat surfaces of the meter section parts as It is

Figure No. 48. Push

ready for assembly in a similar way. Figure No. 45.

PAGE 14