Reassembly of Planet Carrier (CONT) - TM-5-3895-349-14-P0728

20. Position air chamber on air chamber bracket (Fig.

22. install brake shoe return spring (Fig. 177). Before in-

175). Secure with nuts and lockwashers. Tighten

stalling spring, make sure that slack adjusters are ad-

nuts to specified torque. Secure clevis of brake

justed to allow brake shoes to come together as

chamber to slack adjuster with pin and coffer pin.

closely as possible so that spring tension will be at a

minimum during installation. Install spring anchor pin

washers and cotter pins.

CAUTION: Do not use pliers with serrated jaws to as-

semble brake spring. Do not use any tool which will

nick or score spring. This will cause early failure. Tool

shown is broke pliers which has provisions on end of

handle for installing spring.

21. Position broke shoe on spindle support. Retain brake

shoe by inserting brake shoe anchor pin (Fig. 176).

Install second brake shoe in same manner.

23. Lock brake shoe anchor pins with anchor pin set

screws. Lockwire set screws (Fig. 178).

NOTE: On some axles, brake anchor pins are held

in place with retaining plate, bolt, and lockwasher.

Tighten bolt to specified torque.