Reassembly of Internal Gear and Hub

Reassembly of Internal Gear and Hub

1. Position internal gear on hub, aligning matchmarks

made at disassembly. Secure with bolts and locking

plates and tighten to specified torque (Fig. 135).

Lockwire bolts in pairs.

NOTE: Some axles use bolts without locking plates,

with bolts inserted through internal gear and threaded

into hub.

FIG. 137

Reassembly of Brake Shoes

1. Install brake linings on brake shoes with washers and

nuts. Torque nuts to 200 to 220 in. lbs. (Fig. 138).

Tighten nuts in sequence shown in Fig. 139.

FIG. 135

2. Check that bearing seat on hub is free of nicks and

burrs. Press bearing cone on internal gear and hub

using bearing driver (Fig. 136). Bearing driver

dimensions are given in Fig. 137.

FIG. 138

FIG. 136

FIG. 139