Click here to make tpub.com your Home Page

Page Title: Reassembly of Conventional Differential
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

3. Install ring gear. Install bolts so internal diameter of
2
Place pinions and thrust washers on differential
spider, lubricate, and set in position on installed side
ring gear prevents turning of hex head. Install ring
gear bolt nuts and torque to 120 to 135 ft. lbs.
gear.
Position ring gear and flanged hub in press and apply
NOTE: It is very important that tang on each pinion
light press pressure to facilitate torquing nuts (Fig.
thrust washer engages groove in case halves as
102).
shown by arrows in Fig. 104.
FIG. 102
NOTE: Axle Part Nos. 130788, 131507, and 190010
are equipped with NoSPIN differentials. Refer to
Figs. 107 through 118 for reassembly instructions.
FIG. 104
Reassembly of Conventional Differential
3. Align match-marks and install remaining case half on
1. Lubricate and install thrust washer and side gear in
other case half assembly, making sure of full gear
differential case and ring gear assembly (Fig. 103).
engagement (Fig. 105). Install bolts and tighten to
Engage holes in thrust washer on dowels projecting
specified torque.
from thrust washer bearing surface in differential
case.
NOTE: Some differential cases are held together with
thru bolts and self-locking nuts instead of bolts in
tapped holes. The bolt heads must extend from the
ring gear side of the case assembly.
FIG. 105
FIG. 103
35

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business