Click here to make tpub.com your Home Page

Page Title: Disassembly of Standard Differential
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

8. Remove bolts securing seal retainer to carrier and
Disassembly of Standard Differential
remove retainer (Fig. 62). If necessary, tap with
soft mallet to break seal between parts.
1. Match-mark  case  halves  to  insure  correct
reassembly (Fig.  65).  Cut lockwires that secure
differential case bolts.
NOTE: If axle assembly is equipped with NoSPIN
differential,
proceed to Fig.
68 for special
instructions.
9. Screw two bolts in puller holes and pull bearing cage
from carrier assembly (Fig. 63). This pulls outer
pinion bearing cone from shaft.  Turn each bolt
equally to pre- vent damage to carrier, shaft, or
bearings. After bearing cage is pulled out a short
distance,  back off puller screws and insert .030"
shim stock under puller screws before pulling is
continued,  to reduce possible dam. age to shim
2. Remove differential bolts securing case halves. Lift
pack under flange of bearing cage.
off plain case half (Fig.  66).  Use soft mallet if
necessary to aid removal.
NOTE: Some differential case halves are secured
with bolts and self-locking nuts instead of bolts and
lock- wires.
10. Remove pinion shaft assembly from carrier (Fig.
64) Remove bearing cage shims.  Retain bearing
cage shim pack intact for possible reuse in
reassembly.
3. Remove spider, pinions, and thrust washers (Fig.
67).
26

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business