|
|
16 HOLE RING GEAR INSTALLATION AND
ASSEMBLY PRODUCTION
1. REMOVE ALL BURRS FROM FLYWHEEL
MOUNTING FACE AND PILOT BORE, CLEAN WITH
SOLVENT. THE ENGINE FLYWHEEL AND HOUSING
MUST CONFORM TO STANDARD S.A.E. No. 3
(S.A.E. J927) TOLERANCE SPECIFICATIONS FOR
PILOT BORES, ECCENTRICITIES, AND MOUNTING
FACE DEVIATIONS.
2. INSTALL RING GEAR No. 233089 AS SHOWN.
3. INSTALL SPECIAL WASHERS No. 215909 AND
SPECIAL SCREWS No. 233092. TIGHTEN
SCREWS TO 30 TO 33 LBS. FT. TORQUE. LOCK
WIRE IN PLACE AS SHOWN.
FIG. M
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |