Click here to make tpub.com your Home Page

Page Title: Figure 101
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Figure 101
Figure 104
Using new "O" rings install rear output' bearing cap
and taper bearing cup on transmission case. Lube
Install output shaft front companion flange, flange
opening in bearing cap must be aligned with lube
"O" ring, washer and flange nut. Block output gear.
opening in case. Tighten bearing cap bolts to specified
Tighten nut 200 to 250 ft. lbs. torque [27,7-34,5 m.kg].
torque. (See torque chart).
Figure 102
Install front bearing cap and shims. Tighten bolts to
Figure 105
specified torque. Tap output shaft front and rear to seat
taper bearings. Loosen front bearing cap bolts.
From the rear of the transmission case Install the
low clutch assembly.
Figure 103
Using an inch lb. torque wrench, determine the
rolling torque of the output shaft and record. Tighten
front bearing cap bolts to specified torque. Check rolling
torque with bolts tight. Torque must be 6 to 8 inch lbs.
Figure 106
[0,07-0,09 m.kg] more than when bearing cap bolts were
loose. Add or omit shims on the front bearing cap to
From the front of the transmission case Install the
achieve the proper preload.
reverse and 3rd clutch assembly.
19

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business