|
|
3208 INDUSTRAIL AND MARINE ENGINES
DISASSEMBLY AND ASSEMLBLY
CAMSHAFT BEARINGS
REMOVE CAMSHAFT BEARINGS
11-1211
Tools Needed
A
B
1P5545
Adapter Group
1
8S2241
Camshaft Bearing Installation
1
& Removal Group
8H684
Ratchet Box Wrench
1
start by:
a) remove crankshaft and gear
b) remove camshaft and gears
NOTE: The crankshaft does not have to be removed for
removal and installation of the camshaft bearings, but
must be removed to correctly clean the oil passages in
the cylinder block.
1.
Install tooling (B) through the flywheel housing
end of the cylinder block.
2.
Install washer (1) and bolt (2) from tool group
(A) in the end of the shaft of tooling (B).
Remove the bearings from the cylinder block
starting with the front bearing.
3.
Thoroughly clean the oil passages and
surfaces where the camshaft and bearings fit.
INSTALL CAMSHAFT BEARINGS
12-1211
Tools Needed
A
B
1P5645
Adapter Group
1
8S2241
Camshaft Bearing Installation
1
& Removal Group
8H684
Ratchet Box Wrench
1
1.
Start with the rear camshaft bearing and install
the bearings in the cylinder block with tooling
(A) and (B). Make sure the oil holes in the
bearing are in alignment with the oil holes in
the cylinder block.
2.
To install the front camshaft bearing, put tube
(1) from tool group (B) in position shown with
the tube over the boss on the front of the
cylinder block and pull the bearing into place.
Make sure the oil holes in the bearings are in
alignment with the oil holes in the cylinder
block.
end by:
a) install camshaft and gears
b) install crankshaft and gear
95
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |