|
|
3208 INDUSTRAIL AND MARINE ENGINES
DISASSEMBLY AND ASSEMLBLY
CAMSHAFT AND GEARS
REMOVE CAMSHAFT AND GEARS
11-1210 & 1212
Tools Needed
A
B
3P1544
Timing Pin
1
5P2371
Puller Plate
1
Bolt 1/4"-20 NC x 1" long
2
Flat Washer 1/4"
2
start by:
a)
remove timing gear cover and oil pump
b)
remove valve lifters
1.
Remove the plug from the fuel injection pump
housing and install timing pin (A).
2.
While turning the crankshaft clockwise as seen
from the front of the engine, push on tool (A)
until it slides into the groove (slot) in the fuel
injection pump camshaft.
3.
Remove the tachometer drive adapter shaft
(1).
4.
Install tooling (B) into the camshaft drive gear
for the fuel injection pump. Turn both bolts
evenly until the drive gear is free of the shaft.
Remove tooling (B).
5.
Remove thrust pin (2) that holds the camshaft
in place from the rear of the cylinder block.
6.
Remove the camshaft (3) and gears from the
cylinder block as a unit. Be careful not to
cause damage to the camshaft bearing or
journals.
84
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |