|
|
3208 INDUSTRAIL AND MARINE ENGINES
DISASSEMBLY AND ASSEMLBLY
CRANKSHAFT FRONT SEAL
REMOVE CRANKSHAFT FRONT SEAL 11 -1160
Tools Needed
A
1P3075
Puller Group
1
start by:
a)
remove crankshaft pulley
1.
Remove the front seal with tool group (A).
INSTALL CRANKSHAFT FRONT
SEAL 12-1160
Tools Needed
A
5P4194
Installer Assembly
1
1.
Put 7F2770 Cement on the outer metal surface
of the front seal. Put the seal in position on the
short end of the installer assembly (A). The lip
of the seal must be toward the inside of the
engine.
NOTE: If a new wear surface for the front seal is
needed, put the spacer from tooling (A) between the
seal and flange of the installer assembly.
2.
Put the seal and installer assembly in position
on the end of the crankshaft. Install bolt (1)
and washer (2) that hold the crankshaft pulley
in place. Tighten the bolt until the installer
assembly makes contact with the crankshaft
gear. Remove the bolt, washer and tool (A).
end by:
a)
install crankshaft pulley
77
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |