FUEL INJECTION LINES, AIR INLET MANIFOLD

3208 INDUSTRIAL AND MARINE ENGINES

DISASSEMBLY AND ASSEMBLY

FUEL INJECTION LINES, AIR INLET MANIFOLD

REMOVE AND INSTALL FUEL INJECTION

LINES (INDUSTRIAL ENGINE) 10-1262

1. Thoroughly clean the area around each fuel line

connection before removing any fuel lines.

2. Disconnect fuel lines (1) at the fuel injection

pumps and at the cylinder heads. Disconnect

fuel lines at block (2) and at the fuel filter base

(3). Remove the two bolts (4) from the inlet

manifold that hold the fuel lines. Remove fuel

lines (1).

3. Put caps on all openings and plugs in all fuel

lines to prevent dirt or foreign material from

getting into the fuel system.

4. Remove the plugs and caps and install the fuel

lines in their respective positions. Tighten fuel

line nuts to a torque of 30 5 Ib.ft. (4.1 0.7

mkg).

REMOVE AIR INLET MANIFOLD

(INDUSTRIAL ENGINE)

11-1058

start by:

a) remove air cleaner

b) remove fuel injection lines

1. Remove the six bolts (1) that hold the inlet

manifold (4) to the cylinder heads.

2. Loosen clamp (3) and push crankcase ventilator

valve hose (2) away from inlet manifold.

Remove inlet manifold (4).

3. Put tape over the openings in the cylinder heads

to prevent dirt or foreign material from getting

into

the

engine.