Figure 6. Changing Lagging

TM 5-3815-223-14&P

Callouts below refer to

1. Remove capscrews (01) and lockwashers (12).

retainers (08) in roller (06).

Remove nuts (02), lockstrap (03) and washers (04).

7. Set roller up between supports (07) and install pin

2. Drive pin (05) from roller (06) and supports (07).

(05).

Remove roller (06).

8. Install washers(04), nuts(02) and lockstrap (03).

3. Remove bearing retainer (08), felt closure (09) and

Tighten nuts (02) to remove all end play. Rollers should

bearings (10) from roller.

turn free after adjustment. Bend up, jockstraps (03) after

4. Remove and replace (if necessary) bushing {(11)

adjusting.

from support (07). Reinstall bushing (11) into support

9. Install capscrews (01) and lockwashers (12).

(07).

10. Lubricate rollers with GAA grease,

5. Inspect bearings (10) and replace if necessary.

6. Install bearings (10), felt closure (09) and bearing