SPECIAL INFORMATION. - TM-5-2815-231-24P0012

TM 5-2815-231-24P

(4) FIG. Column. This column lists the number of the figure where the item is identified/located in

(5) ITEM Column. The item number is that number assigned to the item as it appears in the figure

referenced in the adjacent figure number column.

c. FIGURE AND ITEM NUMBER INDEX.

(1) FIG. Column. This column lists the number of the figure where the item is identified/located in

(2) ITEM Column. The item number is that number assigned to the item as it appears in the figure

referenced in the adjacent figure number column.

(3) STOCK NUMBER Column. This column lists the NSN for the item.

(4) FSCM Column. The Federal Supply Code for Manufacturer (FSCM) is a 5-digit numeric code

used to identify the manufacturer, distributor, or Government agency, ETC., that supplies the item.

(5) PART NUMBER Column. Indicates the primary number used by the manufacturer (individual, firm,

corporation, or Government activity), which controls the design and characteristics of the item by

means of its engineering drawings, specifications, standards, and inspection requirements to identify

an item or range of items.

5. SPECIAL INFORMATION.

a. USABLE ON CODE. The usable on code appears in the lower left comer of the Description column

heading. Usable on codes are shown as "UOC:.." in the Description Column justified left) on the last line of the

applicable item description/nomenclature. Uncoded items are applicable to all models. Identification of the

usable on codes used in this RPSTL are:

b. ASSOCIATED PUBLICATIONS. The publications listed below pertain to the LCM-8 Engine and

Basic Craft (Rohr and Gunderson).

Publication

Short Title

TM 5-2815-231-14

Engine (V-12) Maintenance Manual LCM-8

LO 5-2815-231-12

Lubrication Order, Landing Craft Mechanized

TM 55-1905-222-24P

Basic Craft RPSTL LCM-8 (Rohr and Gunderson)

TM 55-1905-222-14

Basic Craft Maintenance Manual LCM-8 (Rohr and

Gunderson)

6. HOW TO LOCATE REPAIR PARTS.

a. When National Stock Numbers or Part Numbers are NOT Known.

(1) First. Using the table of contents, determine the assembly or subassembly group to which the item

belongs. This is necessary since figures are prepared for assembly groups and subassembly

groups, and listings are divided into the same groups.

(2) Second. Find the figure covering the assembly group or subassembly group to which the item

belongs.